630101_2_Manual_Propane_Conversion_US.doc
2.0 Isolating the Gas Supply
Before any work is commenced, the appliance must first be shut down,
allowed to cool and then isolated from the gas supply
3.0 Removing the Fascia
The ST900 fascia attaches to the fireplace by four hooks. To remove the
fascia, simply lift it upwards 5/8”-3/4”, and pull towards you. Care should
always be taken when handling the fascia.
To replace the fascia, line up the four hooks with the matching receptacles
on the fireplace and push the fascia into place and let it drop down, the
fascia should now be securely in position.
4.0 Removing the Glass Assembly
Pull the four hooks shown on the following page towards you and then
away from the glass to release the glass frame underneath the hook.
Lift the glass assembly towards you to clear the locating supports and
place it flat upon some newspaper or a sheet of cardboard to protect your
floor coverings.
Do not operate the appliance if the glass has been broken, damaged,
or the glass is not properly positioned/hooked onto the appliance.
To Next Page
Loading...
