Escort ELC-131D - General Specification

WARNING
When measuring in-circuit components, firsts de-energize the
circuits before connecting to the test leads.
The warnings and precautions should be read and well
understood before the instrument is used. The must be carefully
observed during use.
This instrument is recommended to be used by a suitably trained
and competent person.
A WARNING identifies conditions and actions that pose hazard(s)
to the user; a CAUTION identifies conditions and actions that may
damage the transducer. International electrical symbols used are
explained in Table 1.
MC |...
Table 1. International Electrical Symbols
>
General Specifications
Parameters Measured : L/C/R, D/Q
Measurement Circuit Mode :
1) Capacitance/Resistance Measurement—
Defaults to parallel mode for all ranges
+: Parallel measured mode
2) Inductance Measurement-
Defaults to series mode for all ranges
—mw—oo : Series measured mode
Both Series and Parallel mode data can be obtained
through simple key operation (See page 23)
Displays :
L/C/R : Max display 9999 except 10mF(120Hz),
ImF(1kHz) measurement ranges with max
display 1999
D/Q : Max display 999 (AUTO RANGE)
Measurement Terminals : 2 terminals with sockets
Ranging Mode : Auto & manual
Test Frequency : IkHz & 120Hz
Freq Accuracy : +0.01% (1kHz = 1008.06Hz;
120. Hz = 122.07Hz)
Measurement Rate: 1 measurement/second, nominal
Test Signal Level : 0.9 Vrms approx.
Response Time — : Approx. 1 second/DUT (device under test)
(@ manual range)
Temperature Coefficient :
0.05 x (Specified Accuracy)/°C (0°C-<18°C or 28°C -50°C)
Operation Temperature : 0°C to 40°C; 0 - 70% R.H.
Storage Temperature : -20°C to +50°C; 0 - 80% R.H.