Page 3 of 13 0455-0322 Rev A
Wiring Interface
Open the rear case of the device, there is a row of terminal blocks for connecting the power supply,
electric lock control, etc. The connections are as follows:
Reference
Number
Description
1
Ethernet interface: standard RJ45 interface, 10/100M adaptive, Cat5e network cable or
better is recommended.
2
Two sets of short-circuit input detection interfaces: for connecting switches, infrared
probes, door magnets, vibration sensors and other input devices.
3 Wiegand interface.
4 RS485 interface.
5 Power interface: 12V/1A input up positive, down grounded.
6, 7
Two sets of short-circuit output control interface: used to control electric locks, alarms,
etc.
8 Line out interface.
To Next Page
Loading...
