12
5. The display will now show the 2nd ON time. Repeat steps
3-4 until all remaining ON/OFF periods have been set. On
the last OFF period, press the Day button until the next
desired day/block of days you want to programme is
flashing.
6. Repeat steps 3-5 until all days/block of days have been
programmed. Wait 15 seconds to automatically confirm
or press the
Home button. Move the slider to RUN to
return to Run Mode.
N.B. The copy button can be used in the 7 day setting to copy
any chosen day to the next day (e.g Mon to Tues or Sat
to Sun). Simply change the program for that day, then
push copy repeatedly until all 7 days (if you so wished)
have been changed.
Setting the Hot Water Programme
1. Move the slider to HW. Choose between 5/2, 7 day
or 24 hr programmer operation (see page 7)
2. Press the Next
button. Press the Day button until the
desired day/block of days you want to programme is
flashing.
3. The display shows the 1st ON time. Press +/– to set the
time (10 minutes increments). Press the Next
button.
4. The display shows the 1st OFF time. Press +/– to set the
time (10 minutes increments). Press the Next
button.
5. The display will now show the 2nd ON time. Repeat
steps 3-4 until all remaining ON/OFF periods have
been set. On the last OFF period, press the Day button
until the next desired day/block of days you want to
programme is flashing.
6. Repeat steps 3-5 until all days/block of days have been
To Next Page
Loading...
Need help?
General
