Why does my Eskimo Tools auger spin at normal speed but cut slowly through the ice?
If your Eskimo Tools auger spins at normal speed but cuts slowly through the ice, the blades are likely dull, damaged, or incorrectly re-sharpened. Replacing them with new blades should solve the problem.
What to do if my Eskimo Tools auger drills a few inches, then spins in the hole?
If your Eskimo Tools auger drills a few inches and then spins in the hole, it is likely that the blades are defective or dull. The suggested solution is to replace them with new blades.
Stresses reading and understanding all instructions before operating.
Lists critical safety measures for operating the ice auger, including blade handling.
Instructions for attaching the auger to the powerhead using provided tools.
Steps to install the battery guard onto the powerhead with hardware.
Step-by-step guide on charging the battery before initial use.
To Next Page
General