Eskimo ES 5750 - Starting the Programme; Progress of Programme; Loading Door Lock

48 / EN
Washing Machine / User’s Manual
Changing the delayed start period
If you want to change the time during countdown:
1. Press the Delayed Start button. Time will increase by 1 hour each time you press the button.
2. If you want to decrease the delayed start time, press Delayed Start button repeatedly until the
desired delayed start time appears on the display.
Canceling the Delayed Start function
If you want to cancel the delayed start countdown and start the programme immediately:
 
Thus, Delayed Start function will be canceled. The End/Cancel light flashes continuously.
2. Then, select the programme you want to run again.
3. Press Start / Pause button to start the programme.
4.3.12 Startng the programme
1. Press Start / Pause button to start the programme.
2. Programme follow-up light showing the startup of the programme will turn on.
C
If no programme is started or no button is pressed within 1 minute during programme selection process, the
machine will switch to Pause mode and the illumination level of the temperature, speed and loading door
indicator lights will decrease. Other indicator lights and indicators will turn off. Once the Programme Selection
knob is rotated or any button is pressed, indicator lights and indicators will turn on again.
4.3.13 Progress of programme
Progress of a running programme can be followed from the Programme Follow-up indicator. At
the beginning of every programme step, the relevant indicator light will turn on and light of the
completed step will turn off.
You can change the auxiliary functions, speed and temperature settings without stopping the
programme flow while the programme is running. To do this, the change you are going to make must
be in a step after the running programme step. If the change is not compatible, relevant lights will
flash for 3 times.
C
If the machine does not pass to the spinning step, Rinse Hold function might be active or the automatic
unbalanced load detection system might be activated due to the unbalanced distribution of the laundry in the
machine.
4.3.14 Loadng door lock
There is a locking system on the loading door of the machine that prevents opening of the loading
door in cases when the water level is unsuitable.


minutes and the loading door can be opened.


programme. See. "Cancelling the programme"
4.3.15 Changng the selectons after programme has started
Switching the machine to pause mode
Press the Start / Pause button to switch the machine to pause mode while a programme is running.
The light of the step which the machine is in starts flashing in the Programme Follow-up indicator to
show that the machine has been switched to the pause mode.

continuously in addition to the programme step light.