Eskimo ES 5750 - Troubleshooting

52 / EN
Washing Machine / User’s Manual
5 Troubleshooting
Problem Reason Soluton
Program does not start after
closing the door.
Start / Pause / Cancel button was not pressed.  *Press the Start / Pause / Cancel button.
It may be difficult to close the loading door in case
of excessive loading.
 Reduce the amount of laundry and make sure
that the loadng door s closed properly.
Programme cannot be started or
selected.
Washing machine has switched to self protection
mode due to a supply problem (line voltage, water
pressure, etc.).
 To cancel the programme, turn the
Programme Selecton knob to select another
programme. Prevous programme wll be
canceled. (see. “Cancellaton of program”)
Water in the machine. Some water might have remained in the product due
to the quality control processes in the production.
 Ths s not a falure; water s not harmful to
the machne.
The machine enters standby
mode after the programme
starts or it does not take in
water.
Tap is turned off.  Turn on the taps.
Water inlet hose is bent.  Flatten the hose.
Water inlet filter is clogged.  Clean the flter.
Loading door may be open.
 Close the door.
The water connection may be wrong or water may
be cut off (When the water is cut off, washing or
rinsing LEDs flash).
 Check the water connecton. If the water s
cut off, press the Start/Pause key after the
water has been suppled agan to resume the
operaton from standby mode.
Machine does not drain water. Water drain hose might be clogged or twisted.  Clean or flatten the hose.
Pump filter is clogged.  Clean the pump flter.
Machine vibrates or makes noise. Machine might be standing unbalanced.  Adjust the feet to level the machne.
A hard substance might have entered into the
pump filter.
 Clean the pump flter.
Transportation safety bolts are not removed.  Remove the transportaton safety bolts.
Laundry quantity in the machine might be too little.  Add more laundry to the machne.
Machine might be overloaded with laundry.  Take out some of the laundry from the
machne or dstrbute the load by hand to
balance t homogenously n the machne.
Machine might be leaning on a rigid item.  
on anythng.
There is water leaking from the
bottom of the washing machine.
Water drain hose might be clogged or twisted.  Clean or flatten the hose.
Pump filter is clogged.  Clean the pump flter.
Machine stopped shortly after
the programme started.
Machine might have stopped temporarily due to
low voltage.
 It wll resume runnng when the voltage
restores to the normal level.
Machine directly discharges the
water it takes in.
Draining hose might not be at adequate height.  Connect the water dranng hose as
descrbed n the operaton manual.
No water can be seen in the
machine during washing.
The water level is not visible from outside of the
washing machine.
 Ths s not a falure.
Loading door cannot be opened. Door lock is activated because of the water level
in the machine.
 Dran the water by runnng the Pump or Spn
programme.
Machine is heating up the water or it is at the
spinning cycle.
 Wat untl the programme completes.
Child lock is engaged. Door lock will be deactivated
a couple of minutes after the programme has
come to an end.
 Wat for a couple of mnutes for deactvaton
of the door lock.
Loading door may be stuck because of the
pressure it is subjected to.
 Grab the handle and push and pull the loadng
door to release and open t.
Washing takes longer time than
specified in the manual.(*)
Water pressure is low.  
amount of water to prevent poor washng
qualty due to the decreased amount of
water. Therefore, the washng tme extends.
Voltage might be low.  Washng tme s prolonged to avod poor
washng results when the supply voltage s low.
Input temperature of water might be low.  Requred tme to heat up the water extends
n cold seasons. Also, washng tme can be
lengthened to avod poor washng results.
Number of rinses and/or amount of rinse water
might have increased.
 
when good rnsng s needed and adds an
extra rnsng step f necessary.
Excessive foam might have occurred and
automatic foam absorption system might have
been activated due to too much detergent usage.
 Use recommended amount of detergent.