Eskimo ES 5750 - Connecting Water Supply; Connecting the Drain Hose to the Drain

36 / EN
Washing Machine / User’s Manual
4.1.4 Connectng water supply
C


pressure reducing valve if water pressure is higher.
A
CAUTION: 
laundry will get damaged or the product will switch to protection mode and will not operate.
CAUTION: Do not use old or used water inlet hoses on the new product. It may cause stains on your laundry.
1 Tighten the nuts of the hose by hand. Never use a tool when
tightening the nuts.
2 When hose connection is completed, check whether there is
leak problems at the connection points by opening the taps
fully. If any leaks occur, turn off the tap and remove the nut.
Retighten the nut carefully after checking the seal. In order to
prevent the water leaks and resultant damages, keep the taps
closed when you do not use the product.
4.1.5 Connectng the dran hose to the dran
 
A
CAUTION: Your drain house will be flooded if the hose comes out of its housing during water discharge.

make sure that the machine performs water intake and discharge processes without any problem, fix the drain
hose securely.
40 cm
100 cm

cm and a maximum height of 100 cm.

the floor level or close to the ground (less than 40 cm
above the ground), water discharge becomes more
difficult and the laundry may come out excessively
wet. Therefore, follow the heights described in the
figure.
 
immerse the end of the hose into the waste water or do not insert it into the drain for more than
15 cm. If it is too long, cut it short.
 
pinched between the drain and the machine.
 
hose may not be longer than 3.2 m. To avoid water leak failures, the connection between the
extension hose and the drain hose of the product must be fitted well with an appropriate clamp as
not to come off and leak.