4
Quick Start Guide
This guide is designed to get the camera up and running in a matter of moments.
To get the most out of the CanCam and obtain a full understanding of its wide
range of options, please read the manual thoroughly before operating.
Quick Start-up:
Pull battery tab to activate batteries / Install 4 “C” cell batteries in correct•
polarity (+/-) as indicated in the battery compartment.
Insert SD card into the camera.•
Turn switch to CAM to adjust the Time and Date.•
The internal LCD screen displays T blinking.•
Press the [OK] button to start the Time settings.•
Press the [UP] or [DN] button to adjust the Minute setting and press [OK] to•
confirm and move to the Hour setting.
Repeat to set the Hour and then press [OK] to confirm and move to Date.•
Adjust the Month, Day, and Year by using [UP] or [DN] button. Each time you•
finish an adjustment you MUST press the [OK] button to confirm and move to
the next field for adjustment.
Once done, the word - dEL - will be blinking, this stands for Delete menu and•
will allow you to format your SD Card. (This will delete ALL images). Press the
[M] button to exit.
Select PSET (or CAM to input customised settings, see advanced programming)•
PSET This bypasses all user defined settings and uses the following
settings:
(PIR mode / Resolution: 3MP / Burst: 3P / Time out: 30 seconds)
P-SET Factory Default Settings:
Time Out: 30 Sec
Burst Mode: 3 Still Image
Resolution: 3M
Operation Mode: PIR
Video Mode: 10 Seconds (VGA Resolution)
Time lapse setting: 19:00-07:00 (Next day)
To Next Page
Loading...
