11
2. Press the
*
key followed by the 6 key the orange LED will start to
flash.
3. Press the 0 key followed by the 2 key.
The rear tamer is now on.
How to set the length of the pin numbers to be used
1. Enter programming mode by entering the 4 digit pin number twice
(default pin 1234).
A Long bleep will be heard and the green power LED will turn orange.
2. Press the
*
key followed by 9 key the orange LED will now flash.
3. Press 04 a long bleep will be heard.
4. Enter the length of the pin number you require (2,3,4,5 or 6).
If the length is the same as already programmed you will get a conformation bleep.
If you have changed the length you will get 7 bleeps to say it has now been changed.
Note:- Any pin numbers or Tags programmed into the system will be
deleted if the pin length is change.
How to Enable the door Bell function
Note:- If two doors are being controlled the bell function can not be used.
1. Enter programming mode.
A Long bleep will be heard and the green power LED will turn orange.
2. Press the
*
key followed by the 2 key the orange LED will start to
flash.
3. Press the 0 key followed by the 2 key.
The door bell function is now on.
Note: The * key is now used to ring the doorbell
How to Disable the door Bell function
1. Enter programming mode.
A Long bleep will be heard and the green power LED will turn orange.
2. Press the
*
key followed by the 2 key the orange LED will start to
flash.
3. Press the 0 key followed by the 1 key.
The door bell function is now off.
How to reset a lost programming pin number
Note:- this will set the programming Pin back to its default factory setting of
1234 and leave all other settings intact provided Pin length is still 6 digits.
1. Remove power to the keypad/reader for 10 seconds.
2. Apply power and press the # key within 3 seconds
EZ-TAG2 Manual.qxp_Layout 5 29/01/2015 08:16 Page 11
To Next Page
Loading...