TRIMMER
This trimmer is designed only for cutting grass. Never use it for any other purpose. Using the machine for any
other purpose than cutting grass may damage the machine and cause serious personal injuries.
Installation (Fig. 31)
1. Set the inner holder and outer holder correctly to the gear shaft.
2. Screw the bolt (M8 left-hand thread) into the gear shaft and secure it
with a key.
3. Screw the nylon-cutter into the bolt by fixing the inner holder with the L-
shaped key and tighten it manually.
NOTE! Keep the blade bolts and washers in a safe place so that you
won’t lose them.
(1) Gearcase
(2) Bolt
(3) Nylon-cutter
(4) Nylon-cord
Operation
- Nylon cord consumes a lot of power. Please note that the engine rotation speed in operation should be
50% larger as when using a metal blade.
- Nylon cutter cuts grass with the power of cord rotation. If you try to cut grass for the whole length of the
cord at one time, rotation speed becomes lower due to resistance and you cannot cut well. In case of large
resistance, get the nylon cutter away from the grass, make the rotation speed higher and cut a small
amount of grass at a time.
To Next Page
Loading...