65
- Adjust the strap length so that the snap hook (k) is about a hand‘s breadth below the
right hip.
- Hang the cutting tool on a hook.
- When standing in a normal working posture, the blade should touch the ground during
normal working position. Thereby, it is important that the cutting tool is always well bal-
anced.
- For operation, hook the cutting tool into the snap hook (k) of the carrying strap while the
engine is running.
NOTE! In an emergency, the safety latch (Fig. 17, part l) can be pulled from the
harness. The machine then detaches immediately from the carrying strap and
falls to the ground.
Mounting the hedge trimmer. Fig. 40-42
- Place the hedge trimmer (15) precisely as shown in Figure 40 on the connecting rod (3).
- Adjust the slope by unlocking the lock (Fig. 41)
- The hedge trimmer can be tilted from 0 ° to 90 ° (Fig.42).
To Next Page
Loading...