69
8. If any problem occurs, pull the pin of safety belt, then release the brush cutter immedi-
ately. Fig. 17
9. If the machine is hot, the throttle level can be adjusted to ON position directly when re
start the machine.
NOTE: Always pull the starter cord out in a straight line. If it is pulled out at an
angle, then friction will occur on the eyelet. As a result of this friction, the cable
will become frayed and will wear away faster. Always hold the starter handle
when the cable retracts. Never allow the cable to snap back when it has been
pulled out.
NOTE: Do not start the motor in tall grass.
NOTE: When the engine has been switched off, the cutting unit continues running
for several seconds therefore do not touch the cutting unit until it has come to a
standstill!
WORKING INSTRUCTIONS
Check before use!
Check the safe condition of the device:
- Check the device for leaks.
- Check the device for visual defects.
- Check that all parts of the device have been securely fitted.
- Check that all safety devices are in proper condition.
Working with brush cutter / grass trimmer
When working with the equipment as grass trimmer and brush cutter, the appropriate plas-
tic guard hood for cutting blade mode or cutting line mode must be fi tted to prevent objects
being thrown out by the equipment. The integrated blade (A) in the cutting line guard hood
automatically cuts the line to the optimum length. Fig. 18
To Next Page
Loading...