70
When you work with the cutting tool for the first time, familiarize yourself with
the operation and control of the cutting tool blade without running engine.
- The design of the cutting tool allows for operation only at the right side of the user's
body.
- Keep the cutting tool firmly with both hands on the handles.
- Always make sure that the cutting tool continues to rotate briefly after the throttle has
been released.
- Always so that the cutting tool no longer turns in a proper engine idle not press down the
throttle.
- Always work with high speed so you have the best cutting results.
- Poke when working on a stone or a tree, turn off the engine and remove the spark plug
then examine the cutting tool for damage.
WARNING! Always be extra careful when working in difficult terrain and slopes.
Cut tall grass gradually so as not to overload the unit. Always wear safety glasses
and hearing protection and a safety helmet.
Mowing with grass trimmer. Fig. 39
Use the plastic line cassette for a clean cut also at uneven edges, fencing posts, and trees.
- Carefully advance the trimming line to an obstacle, and use the tip of the line to cut
around the obstacle. When the trimming line comes into contact with stones, trees, and
walls, the line wears out or breaks off ahead of time.
- Swing the cutting blade like a normal scythe horizontally from right to left and back
again. You define the cutting height depending on how high you are holding the tool.
WARNING! RISK OF INJURIES! Never replace the nylon line with a metal wire.
Automatic thread trimming. Fig. 37
The cutting tool is delivered with a filled line cassette. This line will wear out during work. To
feed new line, forcefully press the head of the line cassette onto the ground while the engine
is running at working speed. The line is automatically fed due to centrifugal force. The knife
at the line guard will shorten the trimming line to the correct length. Run the trim line ap-
To Next Page
Loading...