77
The angle must also be maintained for all knives. For irregular angles, the chain is run irreg-
ularly, wear quickly and break down prematurely. Since these requirements can only be met
with sufficient and regular exercise:
- A File Holder must be used when sharpening the saw chain by hand. The correct filing
angle marked on it.
- Hold the file horizontally (at a right angle to the guide rail) and file according to the an-
gle mark on the file holder. Support the file holder on the top plate and depth gauge.
- File down. The knife is always from the inside to the outside.
- The file sharpens only in forward motion. Lift it off in the backward motion.
- Do not touch the dynamic links with the file.
- Turn the file regularly continue to avoid a one-sided wear.
- Remove to remove a piece of hard wood, bones raw edges.
All knives must have the same length, otherwise they will also vary. As a result, the chain is
irregular and it increases the risk of damage.
Lubricate angle transmission
Lubricate with lithium-based grease. Remove the screw and put in the grease, turning the
shaft manually until grease emerges, then replace the screw.
Storing the unit
After cutting, clean the unit thoroughly. Store the unit in a dry room allow the motor to cool
down beforehand.
- Keep handles free of oil, so you always have a secure hold.
- Clean the equipment as required with a damp cloth and, if necessary, mild washing up
liquid.
NOTE!
- Always pull out the spark plug each time before carrying out any cleaning.
- Never immerse the equipment in water or other liquids in order to clean it.
- Store the petrol multi garden tool in a safe and dry place out of the reach of children.
STORAGE
NOTE: Never put the appliance into storage for longer than 30 days without carry-
ing out the following steps.
Long term storage of the appliance
If you intend to store the appliance for longer than 30 days, it must be prepared accordingly.
Otherwise the fuel still remaining in the carburetor will evaporate and leave rubbery sedi-
ment. This can cause problems when starting up the appliance and may require expensive
repairs.
1. Slowly remove the fuel tank cap to release any pressure that may have formed in the tank.
Carefully empty the tank.
2. To remove the fuel from the carburetor, start the engine and let it run until the appliance
stops.
3. Leave the engine to cool (approx. 5 minutes).
4. Remove the spark plug (see section ‘Change and clean the spark plug’).
To Next Page
Loading...