Espina XTP115A - Page 79

79
- Contact the authorized service
centre.
- Contact the authorized service
centre.
Machine starts
but stops again.
- Wrong carburetor setting
(idle speed).
- Contact the authorized service
centre.
Engine starts but
the cutting tool
stops
- Cutting tool blocked.
- Internal fault (drive shaft,
gearbox).
- Clutch faulty.
- Turn off engine and remove ob-
ject.
- Contact the authorized service
centre.
- Contact the authorized service
centre.
Machine works
with interrup-
tions (sputter-
ing).
- Carburetor set up incorrect-
ly.
- Spark plug is sooty.
- On/off switch faulty.
- Contact the authorized service
centre.
- Clean the spark plug or replace
it.
- Contact the authorized service
centre.
Smoke is genera-
ted.
- Wrong fuel mix.
- Carburetor set up incorrect-
ly.
- Use two-stroke mixture at a ratio
of 40:1.
- Contact the authorized service
centre.
Machine does
not work at full
power.
- Machine is overloaded.
- Air filter is contaminated.
- Carburetor set up incorrect-
ly.
- Silencer is blocked.
- Do not use force during mow-
ing/trimming.
- Clean the air filter or replace it.
- Contact the authorized service
centre.
- Check the exhaust.
Brush cutter does
not work at full
power.
- Blades are blunt or dam-
aged.
- Cut material is too high (ma-
chine overload).
- Sharpen or replace blades.
- Cut the grass in phases.
Grass trimmer
does not work at
full power.
- Cutting line too short or
damaged.
- Machine is overloaded be-
cause the grass is too high.
- Feed more cutting line through
or replace it.
- Cut the grass in phases.
Cutting line cannot
be fed through.
- Spool empty. - Replace spool.
Pole saw does not
saw, it plucks or
vibrates.
- Chain tension too high.
- Chain blunt.
- Chain attached incorrectly.
- Chain worn.
- Check and reset chain tension.
- Have the chain sharpened or
replace it.
- Re-attach the chain.
- Replace the chain.
Saw chain
becomes hot or
saw chain lubrica-
tion does not
work.
- No oil in the tank.
- Oil line blocked.
- Chain tension too high.
- Chain blunt.
- Refill oil.
- Clean the oil line.
- Set the chain tension.
- Have the chain sharpened or
replace it.