You can use voice commands to enjoy music. First, wake up the device, then say "Sing a song" .
This will launch the music player and start playing built-in music. You can also use voice commands to
pause or skip songs. There are two built-in songs.
Tips:
If the LED light fails to turn on, check whether the module pins are inserted into the right ports.
If the BOX doesn't recognize any command within the designated timeframe, a Timeout message
will appear, and the screen will exit in approximately 1 second.
The default commands are: turn on the light, turn off the light, turn red, turn green, turn blue, sing
a song, next song, pause playing.
Continuous Speech Recognition
More interestingly, the device supports continuous speech recognition after waking up. This feature adds
a natural and seamless quality to voice interaction, enhancing the interactive experience with a human
touch.
How to use
Say "Hi, E. S. P" to wake up the device, and you will hear a beep.
Speak your command. Upon successful recognition, you will hear "OK" , and the device will remain
ready for further commands.
If no command is identified, the device will wait. Should no commands be given within 6 seconds, the
device will autonomously exit the voice control screen and you need to wake it up again.
16
To Next Page
Loading...
