Need help?Do you have a question about the Espressif ESP32 and is the answer not in the manual?
General| Clock Speed | Up to 240 MHz |
|---|---|
| SRAM | 520 KB |
| Wi-Fi | 802.11 b/g/n |
| Bluetooth | Bluetooth v4.2 BR/EDR and BLE |
| GPIO Pins | 34 |
| Operating Voltage | 2.2V to 3.6V |
| Operating Temperature | -40°C to +125°C |
| Processor | Tensilica Xtensa LX6 |
| Flash Memory | 4MB (varies by module) |
| ADC | 12-bit SAR ADC up to 18 channels |
| DAC | 2 channels of 8-bit DACs |
| I2C | 2 x I2C |
| I2S | 2 x I2S |
| Interfaces | CAN 2.0 |
| SPI | 4 SPI interfaces |
| UART | 3 x UART |
Preparing the testing environment and hardware.
List of required hardware components for the test setup.
Steps for preparing the software environment for testing.
Connecting the physical components for the test setup.
Installing the necessary software applications for the test.
Configuring and using the ESP-Launcher tool.
Performing Wi-Fi Transmit (Tx) performance tests.
Performing Wi-Fi Receive (Rx) performance tests.
Performing Bluetooth Transmit (Tx) performance tests.
Performing Bluetooth Receive (Rx) performance tests.
Executing RF tests using manual command input.
Viewing and interpreting the RF test results.
Performing Wi-Fi RF certification testing.
Performing Bluetooth RF certification testing.
To Next Page
