STEP 2:
1. Locate the Right Swing Arm (Upper) (8) and install it through the Swing Arm Bushing
(23) and secure to the Lower swing arm (6). Use M5 Allen Wrench (68) to tighten 2pcs
of 5/16” Button Head Socket Bolts (56) and 2pcs of 5/16" Nyloc Nuts (55) to the swing
arm assembly.
2. Locate the Swing Arm Axle (22) and slide it through the console mast bushings, then
through the Handle Bar Cover (78) and Lower swing arm (6). Use the M5 Allen Wrench
(68) to tighten the 5/16” Button Head Socket Bolt (43) and 8.5mm x 23 Flat Washer
(100) to secure to the Swing Arm Axle (22).
To Next Page
Loading...