STEP 4:
1. Locate Right side Pedal Arm Assembly (2) and install onto the pedal axle at the
large rotating wheel at the rear of the elliptical. Use the M5 Allen Wrench (68) to
tighten the 5/16” Button Head Socket Bolt (98), 5/16" Split Washer (46) and 5/16”
Flat Washer (44).
2. Locate the 1/2" × 70mm Carriage Bolt (29) and slide through the bracket at the front
of the Pedal Arm Assembly (2) and Lower swing arm (6). Use the19m/m Wrench (69)
to tighten the 1/2" Nyloc Nut (30) to the carriage bolt (29).
3. Install Pedal Arm Covers (85, 86) on the Pedal Arm Assembly (2) and use Phillips
Head Screw Driver (68) to tighten the 5 × 12mm Sheet Metal Screw (52).
4. Repeat steps 1-3 above for the left side pedal arm assembly.
To Next Page
Loading...