Esse-ti ST501 - Two Touch Memories

TELEPHONE OPERATION 73
 Press the memory key (M1 ~ M9) where you want to store the phone
number/code.
After a few seconds the display returns to idle state
Note: the stored numbers are preserved under power failure.
Use memory key
 Pick up the handset or press the key.
 Press the memory key (
M1 ~ M9).
Or
 Press the memory key (M1 ~ M9).
 Pick up the handset or press the
key.
Change stored phone number or code
 Follow the steps described in “Store telephone numbers or codes into
memory key”.
The new phone number or code will automatically replace the previous one.
Two touch memories
The telephone has 9 indirect memories (A0~A9).
Review telephone numbers or codes stored
In standby mode:
 Press the MR key and the memory location (2~9 or 0 key).
The telephone number or code stored is displayed.
Store telephone numbers or codes into memory key
In standby mode:
 Press the M+ key.
“Store number” is displayed.
 Dial the phone number/code you want to store (max. 16 digits).
 Press the
MR key and the memory location (2~9 or 0 key) where you
want to store the phone number/code.
After a few seconds the display returns to idle state
Note: the stored numbers are preserved under power failure.