5.2 Before ride ES6
First turn on “Power Switch” on the body of ES6, then use Smart Remote Control and press “Power on/off ” button, when you hear reminding
voice and see the light on Signal Indicator, it means ES6 is started normally.
5.4 Step on and keep balancing
1. Holding the handlebar grip with two hands, and make sure the pedals are on horizontal level;
2. Step on pedals with one foot;
3. , place your center of gravity on the pedal gradually, and raise another foot (thinking how you get upstairs);
4.Avoid moving the turning pipe, and then raising another foot slowly and putting it on the pedal. Just imagine that you are standing on the
ground, keep calm and look ahead instead of looking down when you stand on ES6, trust ES6 self-balancing.
Please make reference to the postures in the following pictures.
5.3 Before step on
Es6 Power Switch
Make sure the pedals are on horizontal level when power on.
For beginners, Please do not hurry to ride it, learn following instructions carefully to protect yourself from any possible injuries.
Standing directly behind ES6, hold the handlebar grip with one hand or two hands, keep the turning pipe upright (almost in no stress), adjust
the handlebar grip until the pedals become horizontal, then step on pedals of ES6.
The more you keep relaxed, the easier you can keep balance. It is much easier than learning to ride a bike. When some people step on
it for the first time, it would waggle in the forward and backward direction, but if you imagine the ES6 as a flat place that can keep balance,
stand upright, keep relaxed, and let your instructor hold the steering bar, you will stop waggling a while later.
30 31
To Next Page
Loading...
Need help?
General