Steam iron
eta
1274
INSTRUCTIONS FOR USE
Dear customer, thank you for buying our product. Before putting the appliance into
operation, read carefully these instructions for use and store this manual properly together
with the certificate of warranty, a cash voucher and possibly with the package and the
internal contents of the package.
I. SAFETY WARNING
– This manual is considered to be a part of the appliance and as such should be passed
on to any other user of the appliance.
– Make sure the data on the type label correspond with the voltage in your socket. The
power cord plug has to be connected to a properly wired and grounded socket according
to the national standards. Use of a separate electric circuit with 16A fuse is recommended.
– The electric socket must be easily accessible, so that the iron can be easily disconnected
in emergency.
– Children above the age of 8 years and persons with reduced
physical, sensory or mental capabilities or lack of experience and
knowledge may use this appliance under supervision or after they
were given instructions concerning the safe use of the appliance
and they understand the hazards involved. Do not allow children
to play with the appliance. Cleaning and user maintenance must not
be carried out by children without supervision.
– Keep the iron and the power cord out of reach of children under
8 years (when it is plugged in or cooling down).
– If the power cord of the appliance is damaged, it has to be replaced
by the manufacturer, service technician or a similarly qualified
person in order to prevent dangerous situations.
– Unplug the device from the power socket, when filling the container
with water during ironing.
– When installing the iron on the stand, make sure the stand is placed
on a stable surface.
– Use and place the appliance on a stable, flat and heat–resistant surface.
– Do not leave the plugged-in iron without supervision!
– The iron must not be used, if it was dropped, shows signs
of damage or leaks.
– Turn off the appliance and disconnect it from the mains by pulling
the power cord from the power socket after finishing work and prior
to accessories or accessible parts replacement, assembly and
disassembly, cleaning or maintenance!
Clara
20
EN
/ 54
To Next Page