Why is my eta Clara not heating up?
Your eta Iron might not be heating up because it is not connected to a power supply. Check the cord, plug, and the socket. Alternatively, the thermostat regulation wheel may be set to the minimal temperature. If so, set the wheel to position • / •• / ••• or MAX.
What to do if my eta Clara does not create steam?
If your eta Iron isn't creating steam, it could be due to a few reasons. First, check if there is water in the container and pour water into it if needed. Second, ensure the steaming regulator is in the steaming position. Lastly, a low temperature setting might be activating the DRIP-STOP function; use the regulation wheel to set a temperature during which you can use steaming and wait until the iron is heated.
Why is water dripping from my eta Iron's ironing plate?
Water might be dripping from the ironing plate of your eta Iron due to several reasons. Ensure the pouring hole lid is properly closed. Also, check if the steam shock function was used when the temperature was set below •••; if so, use the regulation wheel to set a temperature of ••• or MAX. Avoid pressing the SELF CLEAN button during ironing. As a last resort, move the steaming regulator to the rest position, empty the container, and put the iron into the rest position.
Why is brown liquid pouring out of my eta Iron?
If brown liquid is pouring out of your eta Iron, it could be due to improper chemical agents used for removing scale; do not add any chemical agents into the water container for removing scale. It could also be because you're using a type of water that is not recommended; use only common clean drinking water or water diluted with distilled water for filling the container. Another reason may be fibers from linen that got into the holes in the ironing plate and are burning there; clean the iron using the SELF CLEAN function and the steam shock, or vacuum the cooled plate delicately from time to time.
What to do if sprinkling equipment of eta Clara does not sprinkle water?
If the sprinkling equipment on your eta Iron isn't working, first ensure there is water in the container and pour water into it if necessary. If water is present, the water system may be aerated. Tighten your finger on the additional spray jet hole and simultaneously press the sprinkling device button several times.
Why are flakes peeling off the ironing plate of my eta Clara?
Flakes and other impurities peeling off the ironing plate of your eta Iron may be due to using undiluted water with excessive hardness (>15 °N), contrary to recommendations. Use water diluted with distilled water. Also, clean the iron using the SELF CLEAN function and steam shock.
Guidance on selecting appropriate temperatures for different fabric types.
Instructions for using the iron in dry mode without steam.
Detailed steps for steam ironing, including steam levels.
How to use the vertical steaming function for hanging garments.
Procedure for cleaning the iron to remove mineral buildup.
Using the steam shock feature for stubborn creases.
How to use the spray function for moistening fabrics.
Explanation of the automatic shut-off function for safety.
Proper procedures for storing the iron after use.
To Next Page
General