– Steam ironing is not suitable for fabrics from synthetic and silk fibers (e.g. acrylon, nylon,
polyamide or polyester).
– We recommend using soft textile permeable base materials for steam ironing.
– Make sure that the ironed fabric is tensed up properly so that steam does not leak
to the sides.
– For the ironing plate to remain smooth, protect it from direct contact with sharp metal
objects (e.g. zip fasteners, buttons, snap buttons, decorative objects).
Ironing without steaming
Plug the power cord M to electric socket. Put the iron to the rest position (Fig. 7). Turn the
steaming regulator D to the
position, steaming off (fig. 5) or pour out water from the container
I. Set the temperature using regulation wheel H according to the selected fabric material (Fig.
2). Reaching the required temperature is shown by turning the indicator lamp G OFF.
WARNING
– During ironing the thermostat will cycle, which is accompanied by characteristic
sound (clicking). This is normal situation and does not form the reason for warranty
claim related to the appliance.
– To set the temperatures, you just need to turn the thermostat regulation wheel (to the right
/ left) within the given range. Forcible rotation could lead to damaging the regulation wheel.
Recommendation
Control H (Fig. 2) is marked with international symbols that recommend the optimum ironing
temperature and they are the same as marking on some types of laundry and textiles
(Fig. 3). When the temperature is increased from the cold state or if the temperature is set
from higher to lower, we recommend waiting for a while (see the information on the display
and listen for sound signalling) due to stabilization of the ironing plate temperature.
Steam ironing
Hold the iron in your hand, turn the steaming regulator D to the position
(Fig. 5) and slide
the cover C to open the filling container lid. Pour in water to the container I (Fig. 4) with the
enclosed cup O and close the filling hole lid in the opposite direction. Keep the position of
the iron for pouring in water. Put the iron to the rest position (Fig. 7) and set the regulation
wheel H to the marked area for steaming (Fig. 2 - ). Plug the power cord M to a socket.
When the control light G goes off, move the steaming regulator D to the right. The more you
move the regulator towards , the bigger amount of outgoing steam there will be (Fig. 5).
Place the iron to the rest position, automatic creation of steam will stop (more steam may
be going out for a short time).
Warning
– For all normal ironing the middle adjustment of the steam amount is recommended.
Only on ironing the linen fabric, thick cotton and similar fabrics the adjustment of the
steam amount to maximum value is recommended. Setting to pressure steam ironing
is recommended only if the regulation wheel H is set to temperature setting •••.
– Be extra careful to avoid accidental pushing of the SELF CLEAN button.
– When water container I is filled with water over the permitted limit (MAX. 360 ml), steam
can be created even in the rest position.
– At places with hard water we recommend diluting it with distilled water. You will get the
23
EN
/ 54
To Next Page
Loading...