eta GUSTITO - Page 44

44
GB
– A beep signal for about 3 seconds (long beep) will be heard after pressing and holding
the START/STOP button for 3 seconds and the program will end. The same procedure
applies for termination of 60 minutes keeping warm of the bread maker.
3)BARVA(COLOR)button
The button is used for setting of requested browning colour of your bread (SVĚTLÝ-LIGHT,
STŘEDNÍ-MEDIUM, TMAVÝ-DARK). The (▲) on the display shows selected bread color.
Does not apply to programs 8-TĚSTO (DOUGH), 9-MARMELÁDA (JAM),
4)VELIKOST(SIZE)button
This button is used for setting required bread weight for individual programs, i.e. 0.75 kg,
0.9 kg (see the recipes table). The (▲) on the display shows selected bread size.
Does not apply to programs 4-SUPER RYCHLÝ (SUPER FAST), 8-TĚSTO (DOUGH),
9-MARMELÁDA (JAM), 10-DORT (CAKE), 12-PEČENÍ (BAKING).
– 0.75kg size (1.5 LB) = for small bread
– 0.9kg size (2.0 LB) = for large-sized bread
The content of the pan enables preparation of food (bread, cake, dough, meat loaf) up to
the maximum weight of 1.0 kg.
5)MENUbutton
The button is used for selection of the program required. Numbers of the display show
the program selected and its pre-set baking time. You can also use the COLOR(BARVA)
button to dene crust colour and the VELIKOST(SIZE) button to set the bread weight.
Modication of these parameters will automatically change baking times (more time or less
time required).
6)-+(TIME)button
The buttons are used for setting the time required for bread baking and preparation time
and other foods for program 6-BEZLEPKOVÝ(GLUTEN-FREE),7-SUPERRYCHLÝ
(SUPERFAST),9-MARMELÁDA(JAM),12-PEČENÍ(BAKING) cannot be set for delayed
start. For remaining programs it is used for setting of delayed start. The delayed start can
be set from 10 minutes up to 13 hours. The setup time will be added to the preparation
time, i.e. the display will show time required for the program to run.
Example:
It is 20:30 and the bread has to be nished at 7:00 in the morning, i.e. in 10 hours and
30 minutes. Press and hold the + (TIME) button until 10:30 is shown on the display (i.e. time
between now (20:30) and the bread nish time). Conrm setting with the START/STOP
button. The time can be set in 10-minute increments.
Attention
– The timer function (i.e. the delayed start) should be used only for recipes already
successfully tried; do not change the recipes for future breads.
– Excessive amount of dough may overflow and bake on heating element.
– When adding the ingredients in the pan, first pour liquids, then add flour and finally
add dried yeast. Before turning the program on, the yeast may not contact the liquid,
otherwise rising would start prematurely and the dough or bread would collapse later
during baking.
– When working with the time function, do not use perishable ingredients such as milk,
eggs, fruits, yoghurt, cheese, onion etc. as they could be spoiled!