ETC B-Box4 - Page 4

ETC Installation Guide
F-Drive B-Box4
F-Drive B-Box4 Page 4 of 11 ETC
SENSE
1 2 3 4
DMX
IN
DMX
THRU
MAINTAIN
B
B
Ch 4
Ch 3
Ch 2
Ch 1
FDR12FD
FD-BBOX-4R
B
B
FDW1CCD (-CE)/FDW1FTWD (-CE)
A
C
A
D
E
C
D
E
B
B
C
D
E
C
D
E
Driver can be
W1 or R12
Description Notes
A
CC-150Card or
FTW-150Card installed in a
card slot of an F-Drive R12
The CC-150Card and W1CCDriver output constant current, adjustable from 200–700mA.
You must configure each channel of the driver to provide the correct current for the
connected luminaire. See Configure the Output Current on page11 .
The FTW-150Card and W1FadetoWarmDriver are compatible with Navis100 Fade to Warm
luminaires.
W1CCDriver or
W1FadetoWarmDriver
B Category-type cable
†
You must use 0.25mm
2
(23AWG) or larger conductors in Category-type cable.
C ArcSystem Navis luminaires Fixed White or Fade to Warm depending on the W1Driver or R12 output card
D
Alternative:Irideon for
F-Drive luminaires*
Irideon FPZ for F-Drive or Irideon WLZ for F-Drive luminaires
E
Alternative:Source Four Mini
LED for F-Drive luminaires*
*Irideon FPZ for F-Drive, Irideon WLZ for F-Drive, and Source Four Mini LED for F-Drive luminaires require an F-Drive R12
CC-150Card or W1CCDriver (non-emergency installations only).
†
See Electrical and Wiring Specification on page8 .
Note:The illustration is not drawn to scale. Loads are not shown on all outputs of the F-Drive R12 for clarity.
Note: F-Drive-Compatible luminaires will not
function if they are daisy-chained from the output of
the B-Box.
FD-BBOX-4R