ETC Installation Guide
F-Drive B-Box4
F-Drive B-Box4 Page 9 of 11 ETC
Install a Breakout Box
Mount the B-Box4
B-Box4 can be surface-mounted to any structure capable of supporting its weight using the
included mounting plate or hung from a support structure using the mounting plate and tether
(not included).
Mounting Accessories
• Surface-mount:use the mounting plate only (included; ETCpart number 7148A3051)
• Hang:use the 457mm (18in) tether in the breakout box tether kit (not included; ETCpart
number 7148K1018)
Install the Mounting Plate
In order to surface-mount the B-Box4 or attach the tether, you must install the mounting plate.
1. Set the B-Box4 on a flat work surface.
2. Using the Phillips screwdriver, remove the two screws on
the bottom of the B-Box4.
• Save these screws. They hold the top and the bottom
of the B-Box4 together and they will be used to attach
the mounting plate.
3. Attach the mounting plate to the bottom of the B-Box4
using the screws you removed in the previous step.
Surface-Mount the B-Box4
To surface-mount the B-Box4, attach it to the mounting surface
with two M5 (#10) screws.
Hang the B-Box4
The tether has an eye at both ends and one J-hook spring clip.
You can use it in two ways:clip the tether to the B-Box4
mounting plate and attach the eye on the free end of the tether
to a surface, or loop the tether around a support structure and
clip the hook onto the B-Box4 mounting plate and the free end
of the tether.
The tether is not shown to scale; it is 457mm (18in) long.
To Next Page
Loading...