To Next Page

To Previous Page

ETC Setup and Connect Guide

Paradigm 18 inch Touchscreen

P-TS18 Touchscreen Page 8 of 15 ETC

[Install from Online P-CCS]

Virtual Touchscreen Software installs from any discovered and online Paradigm Central Control Server (P-

CCS).

1: Touch to select the [Install from Online P-CCS] button.The Application Shell provides a list of all

discovered Central Control Servers (P-CCS) by IP address. Be patient as this process could take up to

a minute depending on network traffic,

2: Touch to select the server IP from the discovered list, then touch the [Install]. During this installation

process, the touchscreen will shut down then restart again, automatically launching the VTS

application at restart. For instructions on use of Virtual Touchscreen Software, reference the

Paradigm Virtual Touchscreen Setup Guide, available for download on the ETC website at

etcconnect.com.

• To cancel the installation and return to the “General” tab, touch [Cancel].

• To request a refreshed list of online and discovered P-CCS, touch [Refresh List].

Questions and Answers:

Need help?

Do you have a question about the ETC P-TS18 and is the answer not in the manual?

ETC P-TS18 Specifications

General