-13-
with a unit ID; press HOLD key again to release the hold state, and
the leaker continues its measuring; in case stored data reached to
60 groups, press HOLD key again, the “FULL” symbol will display,
which means storage memory is full; press HOLD key to cancel
“FULL” flickering and return to measuring mode.
2）Press HOLD+POWER keys to enter into data access mode and
display Unit 1 storage data automatically; and then press HOLD
key again to turn the page of stored data; NULL will display when
there is no data in stored in the memory, press POWER key to exit
data access mode.
3）After entering into data access mode, press HOLD key for more than
3 seconds will clean up all stored data; when the leaker displaying
“ dEL” symbol, it means that it has finished cleanup process, and
then return to measuring state automatically.
VII Function Quick Look Up
POWER Key Short Press Power on/shutdown/exit
HOLD Key Shot Press Data Holding/release/storage
HOLD Key Pressing
for more than 3s
Peak Holding
(at measuring mode)
HOLD Key Pressing Press
for 3s
Clear Data(at access data mode)
To Next Page
Loading...
