ETC Service Note
Congo™ jr LCD Replacement
Congo™ jr LCD Replacement Page 10 Electronic Theatre Controls, Inc.
Step 13: Remove the 8 face panel LCD Jumper screws
Step 14: Lightly lift each side of the LCD Screen socket circuit board to remove the LCD screen
from the Congo jr face panel.
Step 15: Replace the LCD screen by removing each of the 2 face panel LCD Jumper circuit
boards. Re-attach the LCD jumper circuit boards to the new LCD screen.
Step 16: Place the LCD screen back into the face panel and screw the circuit board into the
standoffs.
Step 17: Place the LCD pressure plate back over the LCD screen and screw the 8 short screws
back into the standoffs.
To Next Page
Loading...