EasyManuals Logo

ETHINK KL6600 User Manual

ETHINK KL6600
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
KL6600
www
.ethink
-
spa.com
2
8. Automatically anti-freeze
9. Single color button backlighting
10. Low-voltage part (Light and Ozone) overcurrent protection.
11. Overcurrent protection of circulating pump
12. Auto Moisturizing (optional)
13. Switchbank, selecting the different functions.
14. Error code hinting
. Function Description
).Initial electrical testing
1.Voltage detection (When A8ON, it would ignore the voltage detection)
When it is initially power on, the system is working at a protecting status. LED shows “
The system is testing the voltage from the input transformer, when input voltage is beyond
280VAC, LED shows “ ”, then the system stops working.
If input voltage is below 280VAC, the system will go into normal power supply.
In a normal power supply, turn off all the loads, and test the input voltage again.
It is normal working voltage if the voltage is below 260VAC, It is the over-voltage if it is
beyond 260VAC, then LED shows “ ”. In these two kinds of situation, the system will not go
into normal operation.
Under this circumstance that the input voltage is normal, the system would go through the
following detections in sequence:
2. The current detection of Ozone
3. The current detection of 12VDC Light
4. The current detection of loads’ auto moisturizing. When B3OFF, it would ignore the
detection.
5. The current detection of circulating pump
). Temperature Setup (77-104/25-40)
Being without any settings, the first time to press ”or“ ”, it enters to temperature setup. At
this time, the setting temperature is flashing in the LED. Before the temperature stop flashing, press
”or“ again, it can change temperature settings. Within 6 seconds without any pressing, it will
exit and save settings temperature, and begin to show the current SPA temperature.
).The Operation of “
1. Press and hold “ for more than 5 seconds until it appears a flashing“ on the LED,
it means that the system enters to the setting mode, and at the same time, it also enters to a
“real-time clock” setting.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ETHINK KL6600 and is the answer not in the manual?

ETHINK KL6600 Specifications

General IconGeneral
BrandETHINK
ModelKL6600
CategoryControl Panel
LanguageEnglish

Related product manuals