KL6600
2. Under the setting mode, click on “ ” to set “start time of filter cycle”, the LED shows
“ ”.
3. The 3rd time to click on “ ” to set “continuous working time of filter cycle”, the LED shows
“ ”.
4. The 4th time to click on “ ” to set “tuning temperature”, the LED shows “ ”.
5. The 5th time to click on “ ” back “real-time clock” setting, the LED shows a flashing
“ ”.
When finish setting, (or being without pressing any setting button within 6 seconds) the data
will be saved, and then it exits the setting mode. Any modification must be operated within 6
seconds.
***Note***
1. When A1 = ON or A2=ON, press “ ”, then it skips the 2nd and 3rd steps.
2. Only “ ” has the operation of “press and hold” and “click pressing”, the other buttons are
“click pressing”
3. “Press and hold” means to click the button and hold until it appears some icons or enters to a
certain status.
4. “Click pressing” means to click the button and let go right now, within a second.
Ⅳ). Working Mode
1. When A1= ON, there is without neither work mode or filter function, “ ” is to control the
heater ON/OFF.
2. The switch of the modes (A1=OFF):
2.1 Three kinds of working modes: Normal Mode, Economy Mode and Filter Mode.
The working mode is just effective for circulation pump、heater、circulation filter and antivirus
function.
2.2 When it is power up, the system is working at the “Filter Mode”, and the LED shows “ ”.
The system is just working during the filter cycle, but the heater doesn’t work in this mode.
2.3 The 2nd time to press “ ”, the system enters to “Normal Mode”, and the LED shows
“ ”. The system is keeping setting temperature all day.
2.4 he 3rd time to press “ ”, then the system goes into “Economy Mode”, the LED shows
“ ”. The system is just working during the first filter cycle, and it will heat the SPA to the
To Next Page
Loading...
Need help?
General
