KL8-3
4
It will add 1 minute when pressing “ ” each time and the minutes could be added the
continually when pressing the “ ” without stop。The adjustment range is 0~59。
It will add 1 hour when pressing “ ”each time，and the hours could be added the continually
when pressing the “ ” without stop。The adjustment range is 0~23。When you set up well of the start
time , you could go on to the next step。
3）、Press“ ” to continual working time setting of Circulation-cleaning， it will show the minimum
continue time is 5 minutes on the LCD， and this time will not flash。 It will add 5 minutes by pressing
“ ” each time，And add 1 hour by pressing “ ”each time。please note that the maximum
of continual time is 19 hours and 55 minutes。 When you set up well of the continual time , you could go on
to the next step。
4）、When everything is setting well，Press “ ”，the system will quit the Circulation-cleaning setting
status with save。
*** Notice ***
1、all setting of Circulation-cleaning must be in Waitting mode status。
2、 Circulation PUMP and OZONE are not working while all setting time。
(5) Pre-heating setting：
Only one pre-heating setting is allowed each day。The LCD can show clearly in the following figures
about whether pre-heating setting status are ON or OFF。
ON
OFF
Fig﹒7：Pre-heat ON Fig﹒8：Pre-heat OFF
Pre-heating setting is in the“Waitting Mode” status and the LCD display “- - -”。
1、 Press“ ”，and enter to Pre-heating setting status，“ON”of the LCD display，The “PREHEAT”
mark is flashed，In the same time，The Preheat start time setting is oning。Press “ ”again，
The Preheat setting will quit in without save。
2）、Press“ ”and“ ”can change the start working time of Preheat ：
It will add 1 minute when pressing “ ” each time and the minutes could be added the
continually when pressing the “ ” without stop。The adjustment range is 0~59。
To Next Page
Loading...
Need help?
General