Warranty
Ethink KL8-3A series control systems are warranted against failure due to manufacturing defects for a
period of 2 years from date of sale to the consumer.
Return to base warranty – The spa pack will be assessed for defect as a result of manufacturing
failure and the faulty part repaired or replaced.
Failure of the unit due to any cause other than manufacturing defect is not covered by warranty. This
includes but is not limited to: Mechanical/physical damage, water damage, rodent or insect damage,
flooding, electrical surge, chemical corrosion damage.
Failure to employ a properly qualified electrical tradesperson to check and test the electrical circuit
and all output devices prior to installing an Ethink KL8-3A control system may result in damage to the
unit.
For example, all pumps, blower and other 240v output devices must be electrically tested for
insulation resistance, motor capacitor condition and checked for any other damage such as water
inside the blower or ozone housing, otherwise damage to the new control circuit board may result.
**************************************Note****************************************
The appliance is not to be used by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction.
Children being supervised not to play with the appliance.
The appliance should be supplied through a residual current device (RCD) with a rated tripping
current not exceeding 30 mA.
Imported and distributed by:
Rev. 03082016
To Previous Page
Loading...
Need help?
General
