Use as a standalone alarm system
The ES-S7A can be connected to wireless accessories
to be used as an independent alarm system.
When the system is armed, if a sensor is triggered,
the siren will ring out and the strobe lights will turn
on.
Connect a wireless sensor
Wireless sensors must be registered in the siren
before being used with it. Press the Connect button
to switch to connection mode. The LED indicators
turn on: you are now in connection mode for 20
seconds. Trigger the accessory (e.g. press any button
on the remote if you want to connect a remote
control). You hear short beeps: the accessory has
been connected to the siren successfully.
The siren supports up to 20 wireless accessories.
Test
Press the “Arm” button of the remote control.
The LEDs of the ES-S7A turn on for 4 seconds: the
connection is successful. Trigger a sensor that is
already connected to the siren, the siren will ring
out. If not, the connection has failed, try registering
the siren again.
To Next Page
Loading...
