Press the ESC button
Press the ESC button
Long press * button
until the system and
settings Led start
blinks (blue+white)
Exit setup mode
Enter Test mode
Exit Test mode
During the test mode, trigger
the connected sensor, the
system will send the SMS,
Push message and 3beeps.
After 1 minutes system return
to disarm mode when no
sensor triggered.
*20*user code*
*21*user code*
*22*user code*
*23*user code*
*30*0*
*30*1*
*0000**
Delete all accessories
Delete RFID tags
Siren setup
Reset to factory
settings
Delete Remote
control
Delete wireless
detector
Clear every connected accessory.
Clear every connected RFID tag.
Clear every connected
Remote control.
Clear every connected
wireless detector.
Deactivate the siren
Activate the siren
The system settings, phone
number and connected accessory
will be restored to default.
Note
- You will hear 2 beeps: the setup is successful.
- You will hear 4 beeps: the setup is failure.
13 Control by SMS
This function applies only if you are using the Alarm system with a
SIM card.
This function enables you to control your alarm system by SMS. This
can especially be helpful if you are located in an area without Wi-Fi or
3G/4G coverage.
To Next Page
Loading...
