SECURITY FEATURES
Function
Tamper Lock Out
Tamper Alert
Sleep Mode
Possible Solution
When an incorrect code is attempted 5 consecutive times, the
Wall Vault™ will go into Lock Out Mode for three (3) minutes.
One (1) long beep, followed by four (4) short beeps will indicate
Lock Out Mode is activated. If the ‘*’ button is touched during
the three (3) minute period, the time will start over. The vault
can not be opened with the touchpad or numeric keypad
during this time.
After a Tamper Lock Out has occurred, the lock will sound a
four (4) beep tamper alert signal each time the vault is
activated until the system is accessed using a valid fingerprint
or pin number.
To conserve battery life, the system will go into Sleep Mode
if it is idle for longer than 10 seconds.
16
4.ai 2/14/2005 11:09:29 AM
To Next Page
Loading...
