ETNA EFE509WIT - Safety Precautions; Hob Safety First Use; Oven Safety First Use

EN 6
Read the separate safety
instructions before using the
device!
Hob
 Before using your hob for the first time,
each element should be switched on to
the highest setting for 3-4 minutes, without
a pan. The manufacturer has applied a
layer of rust-preventer to each element.
When the hob is heated for the first time
a burning smell will be noticeable. This is
normal.
Oven
Prepare for use
When the oven is heated to a high temperature
for the first time, you will smell a “new
appliance” odour. This is to be expected.
 Remove the sticker from the glass panel in
the oven door.
 Remove the protective foil from stainless
steel doors.
 Remove all accessories from the oven
and clean them thoroughly using a dish-
washing detergent. Switch on the closed,
empty oven at the maximum temperature
for about thirty minutes, after which the
grilling element should be switched on for
a period of fifteen minutes. Let the oven
cool off and clean it with warm water.
Replacing the oven light bulb
 Remove the plug out of the socket.
 Unscrew the protective cover in an
anticlockwise direction.
 Replace the bulb with a new one of the
same wattage (230 V -50 Hz - 300 °C).
Screw the protective cover back on, in a
clockwise direction.
SAFETY
Warning: Fit the grid correctly into
any corresponding rack in the oven
cavity an push it to the end
.