GB 25
Symptom Possible cause Solution
Dishwasher detergent
is left in the detergent
compartment.
The detergent compartment
is blocked by dishes.
Load the basket so that the
dishes no longer block the
detergent compartment.
Clean the spray arm.
Steam. When opening the door. This is possible at the end of
the cycle.
Black or grey stains on the
dishes.
Aluminium cooking utensils
have scraped the dishes.
Aluminium can tarnish.
Water remains under the
filters.
This is normal. A small amount of water
around the drain on the rear
of the tub base keeps the
seal flexible.
The dishwasher is leaking. Rinse agent reservoir too full
or rinse agent is leaking.
Take care not to overfill the
rinse agent reservoir. Spilled
rinse agent can lead to foam/
flooding. Wipe up spilled
rinse agent with a damp
cloth.
The dishwasher is not
standing level.
Adjust the dishwasher so that
it is standing level.
Error codes
Symptom Possible cause Solution
The “3 in 1” indicator is
flashing.
Water intake time is too long. Inlet tap not opened.
The “glass” indicator is
flashing.
Appliance overfilled. Water supply is excessive.
Should the appliance become overfilled or exhibit excessive leaking,
shut off the inlet tap and alert the service department.
TROUBLESHOOTING
To Next Page
Loading...
