GB 26
Warning!
The dishwasher must always be placed in a frost-free room.
Electrical connection
This dishwasher is designed for connection to 220-240 V - 50 Hz, with a
fuse of 16 Amp.
Attention!
• Make sure that the voltage and the frequency values for the current
in the home correspond to those on the rating plate.
• Make sure the electrical socket is earthed before connecting the
appliance. If the electrical socket to which the appliance must
be connected is not appropriate for the plug, please consult the
manufacturer or its service agent or a similarly qualified person.
• Do not use an extension cord or an adapter plug with this
appliance.
• Do not, under any circumstances, cut or remove the third grounding
prong from the power cord!
Cold water connection
• Connect the cold water supply hose to a threaded (¾ inch)
connector and make sure that it is fastened tightly in place.
• If the water pipes are new or have not been used for an extended
period of time, let the water run to make sure that the water is clear
and free of impurities. If this precaution is not taken, there is a risk
that the water inlet can get blocked and damage the appliance.
Hot water connection
The dishwasher is not suitable for hot water connection.
Positioning the appliance
Position the appliance in the desired location. The back should rest
against the wall behind it, and the sides along the adjacent cabinets
or wall. The dishwasher is equipped with water supply and drain
hoses that can be positioned to the right or the left to facilitate proper
installation.
INSTALLATION
To Next Page
Loading...
