ETNA LP 14 - Safety Instructions

6
© ETNA Vending Technologies b.v.
Instruction for use LP 14
3 SAFETY INSTRUCTIONS
The LP 14 meets all the requirements
associated with the CE mark.
The following symbols are used in these
instructions:
Ꮨ
This means: take care,
danger of damage to
the machine

This means: take care,
you are taking a risk
☞
This means: important
information
➭
This means: tip
The following safety instructions should be
observed during maintenance operations on the
machine. Neither the manufacturer nor the
supplier will be liable for injury occurring as a
result of irresponsible actions.
• Only qualified staff may remove protection
plates installed in the machine.
• Never work on the machine while someone
else is using it.
• Never use the machine without water in the
boiler.
• Dismantling or modifications to the
machine may only be carried out by
qualified staff.
• Modifications to the equipment are subject
to written authorisation from ETNA Vending
Technologies b.v..
• Connect the machine to the water supply in
accordance with local regulations.
• Connect the mains cable to an earthed wall
socket.
• Never attempt to clean the machine with a
water jet, or to use it in an area where
hoses are used.
• If the connection has to be relocated,
contact the service department of your
supplier.