EasyManua.ls Logo

ETNA OM470RVS/E01 - Removing the Guide Rails; Replacing the Oven Light

ETNA OM470RVS/E01
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN 13
Removing the guide rails
Use conventional cleaning products to clean the guide rails.
1. Grasp the guide rails at the front and pivot them towards the middle of the oven.
2. Remove the guide rails from the holes in the side wall.
3. Take the guide rails out of the oven.
1
2
3
Replacing the oven light
The light is a consumer item and therefore does not fall under the guarantee.
The lamp in this household appliance is only suitable for illumination of this appliance.
The lamp is not suitable for household room illumination.
Cut the power to the appliance by removing the plug from the socket or switching off the
fuse in the fuse box!
Top cavity lamp
Turn the cover to the left to remove it.
Turn the bulb out of the fitting.
Side wall cavity lamp
Use a flat-blade screwdriver to snap and remove the lamp cover from the holder.
Be careful not to damage the enamel.
Turn the bulb out of the fitting.
Note
The light can be very hot! Use protection to remove the bulb.
CLEANING

Table of Contents

Related product manuals