How to fix an ETQ Portable Generator that starts but runs roughly?
If your ETQ Portable Generator starts but runs roughly, start by checking the oil level and fill the crankcase to the proper level, ensuring the generator is on a flat, level surface. Also, make sure the choke is in the correct position and adjust it if necessary. A loose spark plug wire could also be the problem; attach the wire securely to the spark plug.
How to fix ETQ Portable Generator that will not start?
If your ETQ Portable Generator won't start, consider these potential causes: * No propane: Replace the propane tank. * Faulty spark plug: Replace the spark plug. * Unit loaded during start up: Remove the load from the unit before starting.
Why ETQ Portable Generator will not start and runs roughly?
If your ETQ Portable Generator won't start or runs roughly, it could be due to the following: * Low oil level: Fill the crankcase to the proper level and place the generator on a flat, level surface. * Choke in the wrong position: Adjust the choke. * Spark plug wire loose: Attach the wire to the spark plug.
Why won't my ETQ Liquid Propane Portable Generator start?
Your ETQ Portable Generator might not start due to several reasons. It could be that the propane tank is empty, in which case you should replace it with a new one. Another possibility is a faulty spark plug, which would require replacement. Also, make sure the unit isn't loaded during startup; remove any load from the generator before starting.
What to do if my ETQ Portable Generator has no AC output?
If your ETQ Portable Generator isn't providing AC output, begin by checking all cable connections to ensure they are properly connected. Also, the connected device may be defective, try replacing it. Finally, check if the circuit breaker is open and reset it if necessary. For other potential causes, such as a defective capacitor, faulty brush assembly, or faulty AVR, consider contacting a service center. Inspect and tighten all wiring connections, and if the problem persists, contact the helpline.
Why does my ETQ Liquid Propane Portable Generator shut down during operation?
Your ETQ Portable Generator might shut down during operation because it is out of propane; refill the propane tank. Another reason could be a low oil level. If this is the case, fill the crankcase to the proper level and ensure the generator is placed on a flat, level surface.
What to do if ETQ Liquid Propane Portable Generator cannot supply enough power or is overheating?
If your ETQ Portable Generator cannot supply enough power or is overheating, it may be overloaded. Review the load and adjust it accordingly. Also, insufficient ventilation can cause these issues; check for any air restrictions and move the generator to a well-ventilated area.
What to do if my ETQ Portable Generator cannot supply enough power or is overheating?
If your ETQ Portable Generator cannot supply enough power or is overheating: * The generator might be overloaded: Review and adjust the load. * There might be insufficient ventilation: Check for air restrictions and move the generator to a well-ventilated area.
What causes repeated circuit breaker tripping on my ETQ Portable Generator?
Repeated circuit breaker tripping on your ETQ Portable Generator can be caused by: * Overload: Review and adjust the load. * Faulty cords or device: Check for damaged, bare, or frayed wires and replace any defective devices.
General| Brand | ETQ |
|---|---|
| Model | Liquid Propane Portable Generator |
| Category | Portable Generator |
| Language | English |
Warning about the dangers of carbon monoxide produced by generator exhaust.
Precautions against electric shock and short circuits when operating the generator.
Instructions for safe handling and use of fuel, especially LPG.
Importance of proper grounding to prevent electrocution.
Guidance on oil type, capacity, and procedure for changing the engine oil.
Instructions for removing, inspecting, and installing spark plugs correctly.
Overview of the generator's circuit breakers and electrical outlets.
Function of the engine start/stop switch and the hour meter.
Operation of the choke rod for starting and the recoil starter mechanism.
Details of the Reductor Assembly parts and operating the LPG denser device for cold starts.
Step-by-step instructions for attaching the wheels to the generator.
Procedure for assembling and securing the generator's handlebar.
Detailed guide for correctly assembling and installing the generator battery.
Instructions for safely starting the generator, including choke and initial pull.
Guidelines for connecting devices and managing electrical capacity.
Steps for safely shutting down the generator after use.
Advice on keeping the generator clean, dry, and preventing clogs.
Procedures for spark plug inspection and air filter cleaning or replacement.
Table listing common generator problems, their causes, and recommended solutions.
Visual representation of the generator's electrical layout and wire coding.
List of all parts with their corresponding numbers, descriptions, and quantities.
Details on warranty coverage, duration, and conditions for use.
Explanation of what the warranty covers and common reasons for denial.
Owner's duties for maintenance and understanding the ECS warranty.
Form to register the product for warranty and customer service purposes.
To Next Page
