What to do if my ETQ Portable Generator runs but has no electrical output?
If your ETQ Portable Generator's engine runs but there's no electrical output, try these steps: 1. Wait two minutes, then push the circuit reset button to the "on" position. 2. If you're using an extension cord, try a different one. 3. Connect a different electrical device to rule out a problem with the original device.
Why ETQ TG72K12 runs but does not support all electrical devices connected?
If your ETQ Portable Generator runs but can't support all connected devices, it might be overloaded. Try connecting fewer devices. Also, a short in one of the connected devices could be the issue, so try disconnecting any faulty or short-circuited electrical loads. Finally, a dirty air cleaner can cause this problem, so clean or replace it.
Warnings regarding electric shock, short circuits, and touching hot components.
Guidelines for safe refueling and operating the generator in ventilated areas.
Specifies the type and checking procedure for engine oil.
Step-by-step guide for initiating the engine, including manual and electric start.
Guidance on connecting devices and managing generator capacity.
Procedures for safely shutting down the generator.
General| Model | TG72K12 |
|---|---|
| Type | Portable Generator |
| Fuel Type | Gasoline |
| Fuel Tank Capacity | 6.6 Gallons |
| Engine Displacement | 420cc |
| Engine Type | 4-stroke OHV |
| Voltage | 120/240V |
| Starting System | Electric Start |
| AC Outlets | 4 x 120V 20A, 1 x 120/240V 30A |
| DC Output | 12V/8.3A |
| Noise Level | 72 dB |
To Next Page
