What to do if my ETQ Portable Generator runs but has no electrical output?
If your ETQ Portable Generator runs but provides no electrical output, there are a few things to check. First, ensure the circuit reset button is in the "on" position—wait two minutes before pressing it. If you're using an extension cord, try a different one. Also, test the generator with a different electrical device to rule out a problem with the connected device.
Why does my ETQ Portable Generator run, but not support all connected electrical devices?
If your ETQ Portable Generator runs, but struggles to support all connected devices, it might be overloaded. Try connecting fewer electrical loads to the generator. Also, there could be a short in one of the connected devices, so try disconnecting any faulty or short-circuited electrical loads. A dirty air cleaner can also cause this issue; clean or replace it to resolve the problem.
General| Engine Type | 4-stroke OHV |
|---|---|
| Starting System | Recoil |
| Fuel Type | Gasoline |
| Rated Voltage | 120V |
| Rated Frequency | 60 Hz |
| DC Output | 12V/8.3A |
| Noise Level | 68 dB |
Diagram and numbered list identifying various controls and components of the generator.
Importance of proper grounding to prevent electrocution and static discharge.
Guidelines for preventing electric shock, including grounding and avoiding wet conditions.
Warning about touching hot surfaces like the muffler after operation.
Safe practices for refueling, including avoiding ignition sources and cooling time.
Avoid touching hot engine parts and surfaces after operation; do not modify the generator.
Guidance on not overloading the generator and connecting loads after starting.
Steps to follow before and during engine startup, including checks and fuel valve operation.
How to connect electrical loads, including warm-up, load sequencing, and frequency/phase limits.
Procedure for safely shutting down the generator, including unplugging loads and turning off fuel.
Instructions for cleaning the generator's exterior and cooling components.
Procedures for checking and cleaning the spark plug, including gap measurements.
Detailed list of all parts, including part numbers, descriptions, and quantities.
Exploded view and parts list for the generator's crankcase assembly.
Exploded view and parts list for the push rod and valve rocker components.
Exploded view and parts list for the cylinder head and cylinder head cover assemblies.
Exploded view and parts list for the crankcase cover assembly.
Exploded view and parts list for crankshaft, piston, and tie-rod assemblies.
Exploded view and parts list for the carburetor and air cleaner assemblies.
Exploded view and parts list for the flywheel and recoil starter components.
Exploded view and parts list for the ignition coil assembly.
Exploded view and parts list for the regulating control system.
Explanation of what is not covered by warranty, including normal wear and improper maintenance.
Details owner's responsibilities and the emission control system warranty.
To Next Page
