ETQ TG12L31 - User Manual

Questions and Answers

D
Derek HolmesAug 1, 2025
Why won't my ETQ TG12L31 Portable Generator start?
- A
  Andrew KingAug 1, 2025
  If your ETQ Portable Generator engine won't start, several factors could be the cause. Here's what to check: * Ensure the engine switch is in the "on" position. * Verify the fuel valve is set to "open." * Close the choke. * Make sure the generator has enough gas, and that the gas isn't old or contaminated; if it is, replace it. * Inspect the spark plug; clean or replace it if necessary. * Confirm the generator is on a level surface to prevent the low oil shutdown from activating. Add or replace oil if the oil is low.
M
Mr. Clayton Stephens MDAug 11, 2025
What to do if my ETQ Portable Generator engine runs but has no electrical output?
- S
  Scott MillerAug 11, 2025
  If your ETQ Portable Generator runs but provides no electrical output, there are a few things you can check: 1. Ensure the circuit reset button is in the "on" position. Wait two minutes before pushing the circuit reset button to the "on" position. 2. If you're using an extension cord, try a different one, as the connecting wires/cables may be faulty. 3. Try connecting a different device to rule out a problem with the electrical device itself.
G
Gail DavisAug 21, 2025
How to fix an ETQ TG12L31 that runs, but does not support all electrical devices?
- G
  Garrett NealAug 22, 2025
  If your ETQ Portable Generator runs but cannot support all your electrical devices, consider the following: * The generator might be overloaded. Try connecting fewer devices to reduce the load. * A connected device might have a short circuit. Disconnect any electrical loads that are faulty or short-circuited. * The air cleaner could be dirty. Clean or replace it.