Etrel INCH - FIRST CHARGING SESSION; Charging Modes Explained

str. 8
to heat the LCD
before it is turned
ON.
LCD hasn’t been
turned on, there
might be a problem
with the LCD.
Steady glowing
green light
Charging station
is ready to be
used.
If charging station
is not responding
after it is powered
up, something
might be wrong
with connection.
Check the
protection elements
if either RCD or
overcurrent
protection has been
tripped. Activate the
protection. If
nothing helps call
the support or
installer.
No lights
/
If charging station
is not responding
after it is powered
up, something
might be wrong
with connection.
Check the
protection elements
if either RCD or
overcurrent
protection has been
tripped. Activate the
protection. If
nothing helps call
the support or
installer.
Green light is
blinking
LCD is turned on
and charging
station is ready
to be used.
When the LCD
starts the logo
will be first
displayed and
after that you can
start using the
charging station.
LCD is turned on
but freezes and is
unresponsive.
Try resetting the
charging station. If
the problem
repeats there might
be a problem with
the software. You
should call the
support.
You can read the
resetting procedure
in chapter 6
Troubleshooting.