EUFY T2108 - Using Your RoboVac; Important Tips Before Use; Preparation Steps

12 13
English English
Using Your RoboVac
Important Tips Before Use
a
b
c
d
e
f
a
Remove power cords and small objects from the floor that may entangle RoboVac. Use
the provided cable ties to organize your wires and power cords.
b
Fold tasseled edges of area rugs underneath to prevent tangling RoboVac. Avoid
cleaning very dark-colored high-pile rugs or rugs thicker than 1.02 in/26 mm as they
may cause RoboVac to malfunction.
c
We strongly recommend placing physical barriers in front of fireplaces and certain
areas (i.e. air vents) that may cause damage to RoboVac if entered.
d
Keep RoboVac away from wet areas during cleaning.
e
RoboVac may climb on top of objects less than 0.63 in/16 mm in height. Remove these
objects if possible.
f
Anti-drop sensors prevent RoboVac from tumbling down stairs and steep drops. They
may work less effectively if dirty or used on reflective/very dark-colored floors. It is
recommended to place physical barriers to block off areas where RoboVac may fall,
such as stairs covered by carpets or the rounded edges of wood floors.
Preparation
Install the side brushes before use.
Turn on the main power switch on the bottom of RoboVac.
Remove the sticker next to the power switch, and the foam blocks beside the
bumper before use.
Place the Charging Base on a hard, level surface and against a wall.