Eureka E65 - FILLING THE DETERGENT SOLUTION TANK; WARNING: DO NOT POUR FLAMMABLE LIQUIDS INTO THE TANK.; ADJUSTING THE SOLUTION QUANTITY ON THE BRUSHES (WATER + DETERGENT)

23
SPLASH GUARD LIFTING FOR PRE-WASHING
1
2
2
When using the machine to wash floors particularly filthy, it is recommended to pre-wash the floor, allowing the chemical
product of the detergent solution to act more effectively to remove dirt.
Therefore, wash the floor without collecting the solution with the squeegee.
During this operation, it is recommended to lift the splash guard of the machine to allow an even distribution of the
detergent product on the floor.
Go over the area again after several minutes in order to dry the floor, once the splash guard is lowered and the vacuum
function is engaged.
Follow the instructions below to lift the splash guard:
• Stop the machine in a levelled area, turn off the machine and remove the keys;
• Lower the brush plate following the procedure described above;
• Use one hand to lift the splash guard (pos. 1) upwards;
• Rotate the 4 locking levers into the direction indicated by the arrows. In this manner, the splash guard will remain lifted
from the floor.
• Once the pre-wash operation is completed, release the levers (pos. 2) and allow the splash guard to descend (pos. 1).